CM Labs Workstation Console Manual de servicio descargar pdf (Pagina 83)

Maintenance

4-21

Disassembly Procedures (90387)

Tools Required

• Static mat

• Static wrist strap

• #1 and #2 Phillips screwdrivers (#2 driver > 7.5” shaft length)

• Standard flat screwdriver

Backup Battery Replacement

1. Locate the hinged cover on the rear of the unit.

2. Remove one (or two, if applicable) screw holding the battery case closed.

3. Remove and properly discard the old battery.

4. Position the new battery, taking care not to pinch the wires when closing the cover.

Divider Removal

1. Open the top and bottom module slot doors on the left side of the unit to expose the divider.

2. Press the snaps located at the front of the divider and pull the divider out of the module

housing cavity approximately one inch (2.54 cm).

3. With only the top door open, turn the outside edge of the divider toward the center of the

module housing until the divider is free from the chassis and can be removed from the

module housing cavity.

4. Reverse the removal procedure to re-install the divider, making sure the long front leg of the

divider points to the center of the module housing chassis.

CAUTION:

• Before beginning any disassembly procedures, power OFF the monitor and

disconnect the AC cord from the AC power receptacle.

• The external power supply is not designed for disassembly.

• It is recommended that you change the battery yearly.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 119 120

Sin comentarios

CM Labs Workstation Console Manual de servicio Pagina 83